3
PRE-INSTALLATION INSTRUCTIONS FOR DEALERS
The manufacturer has preset the water treatment unit’s sequence of cycles and cycle times.
The dealer
should read this page and guide the installer regarding hardness, day override, and time of regeneration,
before installation.
For the installer
, the following must be used:
• Program Installer Settings: Day Override and Time of Regeneration.
• Read Normal Operating Displays
• Set Time of Day
• Read Power Loss & Error Display
For the homeowner
, please read sections on Bypass Valve and Operating Displays and Maintenance.
During operation, the normal user display is
time of day
and
gallons per minute
.
Flow Rate, Capacity Remaining and Days to a Regeneration
are optional displays but are not normally used. Each of
these can be viewed by pressing
NEXT
to scroll through them. When stepping through any programming, if no buttons
are pressed within 5 minutes, the display returns to a normal user display. Any changes made prior to the 5 minute
time out are incorporated. To quickly exit any Programming, Installer Settings, etc., press
SET
CLOCK
. Any changes
made prior to the exit are incorporated.
If desired, two regenerations within 24 hours are possible with a return to the preset program.
To do a
double regeneration
:
1. Press the
REGEN
button once. “REGEN TODAY” will flash on the display.
2. Press and hold the
REGEN
button for three seconds until a regeneration begins.
Once the valve has completed the immediate regeneration, the valve will regenerate one more time at the preset.
