Water Depot Deluxe Series, Owner'S Manual

Page: 18 / 31

17
REGENERATION MODE
Typically a system is set to regenerate at a time of low water usage. An
example of a time with low water usage is when a household is asleep. If
there is a demand for water when the system is regenerating, untreated
water will be used.
When the system begins to regenerate, the display will change to include information about the step of the
regeneration process and the time remaining for that step to be completed. The system runs through the steps
automatically and will reset itself to provide treated water when the regeneration has been completed.
MANUAL REGENERATION
Sometimes there is a need to regenerate the system
sooner than when the system calls for it, usually referred
to as manual regeneration. There may be a period of
heavy water usage because of guests or a heavy laundry
day.
To initiate a manual regeneration at the preset delayed
regeneration time, when the regeneration time option is
set to “NORMAL” or “ on 0”, press and release “REGEN”.
The words “REGEN TODAY” will flash on the display to indicate that the system will regenerate at the preset
delayed regeneration time. If you pressed the “REGEN” button in error, pressing the button again will cancel the
request. Note: If the regeneration time option is set to “on 0” there is no set delayed regeneration time so “REGEN
TODAY” will not activate if “REGEN” button is pressed.
To initiate a manual regeneration immediately, press and hold the “REGEN” button for three seconds. The system
will begin to regenerate immediately. The request cannot be cancelled.
Note: For soft
eners, if brine tank does not contain salt, fill with salt and wait at least two hours before regenerating.
SET TIME OF DAY
The user can also set the time of day. Time of day should only need to be set
after extended power outages or when daylight saving time begins or ends. If
an extended power outage occurs, the time of day will flash on and off which
indicates the time of day should be reset.
STEP 1U
– Press CLOCK.
STEP 2U
STEP 2U -
Current Time (hour): Set the hour of the day using ▲ and ▼
buttons. AM/PM toggles after 12. Press NEXT to go to step 3U.
STEP 3U
-
Current Time (minutes): Set the minutes of the day using ▲ and ▼
buttons. Press NEXT to exit Set Time of Day. Press REGEN to return to
previous step.
STEP 3U
STEP 1D
STEP 2D
STEP 3D
STEP 4D
STEP 5D