Water Co Admiral, Installation & Operation Manual

Page: 9 / 16

PLeaSe ReaD
1. These terms and conditions carefully, as failure to comply may affect your legal rights under this warranty; and
2. Any operation instructions carefully before commencing use of any product manufactured/Distributed by Waterco Limited (“Waterco”). Waterco
manufactures quality pool and spa products to the highest standards using the most advanced technology and production procedures available.
WaRRaNtY coVeR
If a defect occurs in any Waterco product during the warranty period, Waterco will at its discretion, repair the product or replace and install
the defective part, free of charge provided that the defect results solely from poor workmanship or materials and subject to these terms and
conditions.
Labour is covered by this warranty for a period of 2 years from the date of purchase or installation, within a 25 km (15 miles) radius of an
authorised Waterco Service Agent.
The purchaser is responsible for any freight incurred.
Warranties are valid only within the original country of purchase. Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law [applicable only to Australian States and Territories]. You are entitled to a replacement or refund for a major failure and
compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if goods fail to
be of acceptable quality and the failure does not amount to a major failure.
WaRRaNtY PeRIoD
Waterco Admiral Robotic Pool Cleaners are covered by a two year warranty.
All warranty periods commence on the date of purchase by the end user.
The provisions of this warranty are not transferable and are in addition to and not in modification of or subtraction from any applicable
statutory warranties, rights or remedies.
coNDItIoNS oF WaRRaNtY
This warranty only applies where:
1. The products requiring installation have been sold with installation included and have been installed by a licenced plumber, electrician or
person who has completed an accredited course in swimming pool care and maintenance or a person with more than 1 year on the job
learning or a person supervised by one of these people, in accordance with any written installation instructions provided.
2. The products have been installed and operated in accordance with written instructions supplied by Waterco;
3. The purchaser is able to provide proof of purchase that specifies the date of purchase;
4. The product has been serviced or maintained regularly. (at least once a month).
5. Any pool and spa equipment has been used in water:
a. With a temperature not exceeding 40ºC (104ºF);
b. With a pH range maintained between hte pool water chemistry above mentioned 7.2 to 7.8;
c. That has been chemically balanced in accordance with the Langelier saturation index within a range of -0.2 to + 0.2 to ensure that it is
not corrosive or scale forming;
d. That is not salt water (other than mild saline water conditions which are compatible with swimming pool salt water chlorination systems) –
unless otherwise stated by Waterco in both the respective product labels and brochures that it is suitable for seawater applications; and
e. That has been regularly treated with a sanitising system using bromine, chlorine in one of its compound forms, or generated in-situ,
in concentrations (doses) recommended by the relative state or territory health departments. (In areas outside of Australia please refer to
the local health department recommendations before use);
6. Electrical equipment has been adequately protected from salt air environments and from salt water; and
7. All repairs and replacements shall be carried out by Waterco or its authorised service dealer, unless otherwise authorised in writing
by Waterco.
8. If an authorised service dealer is not available within 25 km (15 miles) of the purchaser’s area:
• The purchaser must contact the place of purchase or Waterco for further instructions and;
• The purchaser is responsible for any freight or infield labour costs.
9