ReMoVING tHe cLeaNeR FRoM tHe PooL
n
Slowly pull the Admiral’s power cord to retrieve the cleaner to the water surface and pool edge.
(DO NOT PULL THE CLEANER OUT OF THE POOL BY THE POWER CORD).
n
Reach down and grasp the handle of the Admiral and remove it from the pool as shown in Fig 1 and Fig 2.
Note:
The Admiral should be stored in an area that will afford some protection from the elements to insure that it retains its finish.
cLeaNING tHe RobotIc PooL cLeaNeRS FILteR baG
Note:
It is strongly recommended that the Admiral’s filter bag should be cleaned after every use.
n
Turn the Admiral upside down and place on the ground or stable surface so the bottom lid is exposed.
n
Turn the two front red locking pegs (a) inwards as indicated by the two arrows moulded into top lid to the unlocked position
as shown in Figure 3.
n
Next press the two red locking clips inwards (b) located at the rear of the cleaner lid and lift the bottom lid out of cleaner housing.
n
Hold the bottom lid as shown in Figure 4 and pull the tab marked “PULL TO REMOVE BAG”
n
Turn filter bag inside out and hose out all remaining debris as shown in Figure 5. If filter bag is very dirty it may be washed in
a washing machine.
Note:
When using a washing machine it is recommended to turn the filter bag inside out and wash using cold water (only) and a mild detergent
without any other item within the wash.
Note:
Do NOT use a clothes dryer.
n
Hose all debris out of the Admiral bottom lid being sure to remove all dirt from the fine filters situated on the intake doors as shown
in Figure 6.
5
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
a
b
b
Summary of Contents for Admiral
Page 14: ...NOTES 14 ...
Page 15: ...NOTES 15 ...
