Water Co Admiral, Installation & Operation Manual

Page: 6 / 16

n
To reattach the filter bag to the bottom lid, turn the filter bag right-side-out.
n
Start at the back of the filter bag and bottom lid where the filter bag says
“Warning: Push bag behind bottom lid TAB” and insert the filter bead into the
channel, so that the tabs are holding the filter bag in near the label with
the words “Warning: Push bag behind bottom lid TAB”, as shown in Figure 7.
Note:
Visually ensure the Admiral’s filter bag is correctly seated into the cleaner’s
bottom lid retaining channels particularly the corners. Refer Figures 7 - 7a
Note: Press the filter bag bead down all the way around the perimeter making sure
that it is completely seated and behind all the tabs as shown in Figure 7b.
WHEN REFITTING THE BOTTOM LID TO THE CLEANER, MAKE SURE ALL FILTER BAG
MATERIAL IS INSIDE THE CLEANER OTHERWISE THE LID WILL NOT CLOSE AND LOCK
INTO PLACE PROPERLY.
n
Once the bottom lid is properly seated, turn the red locking pegs in the
opposite direction of the arrows moulded into the bottom lid until it locks
between the two raised locks. Refer Figure 7c.
n
Press the rear section of the bottom lid into the cleaner while pushing the
locking clips towards the edge of the cleaner until an audible click is heard
as shown in Figure 7d.
Note:
Ensure the Admiral’s filter bag is completely enclosed within the cleaner housing
as the bottom lid will not close properly, and the cleaner will not operate.
PoWeR coRD MaINteNaNce
In the course of using your Admiral, the blue power cord may become twisted or
tangled.
the admiral Kink Resistant Power cord advantage
The Admiral Robotic Pool Cleaner has a specifically designed kink resistant
power cord using a one piece extruded technology that prevents the cord from
delaminating, protecting the internal wires from shorting out and extending it’s
operating life.
If you refer to the power cord (Fig 8 below), there are no layers as the cable & wires
are manufactured simultaneously. The coating of the cable is injected with air to form
small pockets that allow it to float, so the outer layer takes the place of (3) layers of
a typical cable.
Figure 7
Figure 7b
Figure 7a
6
admiral Robotic cleaner cable
Foam casing
air Pockets
(enlarged in diagram)
Wire Inner core
(+/- coated in non-conductive material)
Fig 8
Note: Ensure Filter Bag bead is
located behind bottom lid tab.
Figure 7d Figure 7c
INcoRRect INStaLLatIoN