Vehicle Installation Instructions
WGD00085 REV B1
Page 8
2.
Drill a
¾ inch
hole for the antenna cable.
[Figure 5]
Figure 3
Figure 4
Figure 5
3.
After the hole is made, sand the paint off the interior metal around the hole to ensure a good
ground.
[Figure 6]
4.
Remove the NMO exterior nut.
5.
Ensure that the antenna mount ridges come in contact with the bare metal.
[Figure 7]
Figure 6
Figure 7
6.
Feed the antenna cable connector end first through the ¾ inch exterior hole in the roof of the
vehicle.
[Figure 8 and 9]
7.
Tilt the antenna mount and guide it into the hole and center the flange in the drilled hole.
[Figure 10]
Figure 8
Figure 9
Figure 10
