Vehicle Installation Instructions
WGD00085 REV B1
Page 12
Figure 16
Figure 17
3.
Pull the power cable to the battery.
4.
Pull excess cable out past the battery side of the firewall (leave some slack for a drip loop).
Figure 18
5.
Also pull the Chassis ground extension wire to the vehicle battery at this time, if possible. It is
easier to route the chassis ground cable with the rest of the cables. (The extension cable is not
included, use an additional cable for this function)
6.
You can either wind up and tie off the excess cable or cut off the excess cable where necessary.
7.
Strip / remove approximately 3-5” of the external black sheathing and the foil Mylar shielding
from the power cable.
Grommet access
through firewall
