9
First Generation Connector
Box - Terminal Block
top view end view
Second Generation Connector Box -
Interior View (with Terminal Block)
To reassemble the Cable Assembly:
1.
For a first generation box, thread the cable end through the
strain relief (it can help to remove the outer strain relief nut
completely, slipping it over the cable, and reattaching it
after the cable has been threaded through the strain relief).
2.
Thread the six wires into the holes on the side of the termi-
nal block, and tighten the screws to secure the wires. The
wire colors should be matched to the marked terminals as:
•
TD(A) or TDA
Yellow
•
TD(B) or TDB
Orange
•
RD(A) or RDA
White
•
RD(B) or RDB
Blue
•
GND
Black
•
+12VDC or +12
Red
3.
Hand-Tighten the outer strain relief nut (first generation),
or secure the cable with a wire tie through the two holes on
the circuit board (second generation).
4.
Slide the “battery cover” back onto the connector box (first
generation), or press the two case halves together, making
sure the LEDs are under the holes next to the label (second
generation).
