Wasserhaus Deutschland GmbH· Max-Wundel-Strasse 12 · D-14469 Potsdam ·
Tel. 0331 – 505 79 43 · Fax 0331 – 505 79 52
www.wasserhaus.de · e-mail: [email protected]
page
5
NOTE: Tubing lengths supplied with the system allow for the easy moving of the filter
assembly for servicing. If tubing lengths are shortened for a neater appearance, it may be
necessary to keep the filter assembly in its installed location for service.
Before you begin to install the RO system
CAUTION: A refrigerator icemaker may not operate properly when connected
to a reverse osmosis system that has been installed on a water system that
operates outside of the specified pressures listed on page 31.
CHECK YOUR WATER SUPPLY: The COLD water supply to the RO system must be within
certain quality limits. See the specifications on page 31. If the supply water is not within the
limits defined, the RO system will not make product water as it should and substantially
reduced filter and membrane life will result.
CAUTION: Chlorine in the water will destroy the RO membrane. Most cities
add chlorine to the water supply to kill bacteria. The pre-filters will remove the
chlorine up to the limits shown in the specifications on page 31 before it enters
the RO membrane. It is important to replace the pre-filter cartridges at the
recommended time intervals. See System Care and Maintenance starting on
page 17.
CAUTION: Before consuming any water from the RO system you must
PURGE the RO membrane cartridge.
The RO cartridge contains a food grade preservative that should be removed
before consuming the water from the system. This procedure is explained on
page 15.
CHECK LIST:
1. Reverse Osmosis Unit
2. Water storage tank, 4 gallon volume (2.5 gallon )
3. Four or five colored tubing (black, blue, red, white, yellow-for RO6/RO7 only) ¼” O.D.,
7 feet each color
4. Installation kit, tank ball valve, drain saddle valve, feed water adapter, faucet
assembly, 2 plastic inserts.