Wasserhaus Deutschland GmbH· Max-Wundel-Strasse 12 · D-14469 Potsdam ·
Tel. 0331 – 505 79 43 · Fax 0331 – 505 79 52
www.wasserhaus.de · e-mail: [email protected]
page
19
Step 4: Mounting the tank ball valve
NOTE: Do not tamper with the air valve on the lower side of the storage tank. It has been
preset to 0,5 bar (7,25 psi) at the factory (in an empty storage tank).
We have added a disinfection capsule to the installation kit. It is an Micropur MC10 T
capsule from the manufacturer Katadyn.
Before you start to mount the storage tank, you must insert the disinfection capsule
into the opening of the storage tank. Then mount the tank ball valve according to
following steps
1. Unplug the plastic cap on top of the tank.
2. Put the Teflon tape (approx. 8 rounds) around
the thread.
3. Connect the ball valve to the thread. Hand
tightens only. Do not use a wrench or over tighten
it. BE CAREFUL NOT TO CROSS THREAD THE
PLASTIC VALVE.
4. Connect the other free end of the 1/4" RED
tubing to the Stage 5 post-filter.
5. Close tank ball valve (turn handle vertical to red
tube)
