Wasserhaus Deutschland GmbH· Max-Wundel-Strasse 12 · D-14469 Potsdam ·
Tel. 0331 – 505 79 43 · Fax 0331 – 505 79 52
www.wasserhaus.de · e-mail: [email protected]
page
17
Step 2: Mounting the drain saddle valve
The drain saddle valve should fit most standard drain pipe. It should be installed above the
trap and on the vertical or horizontal pipe.
1. Position the drain saddle in desired location, mark spot. You need to consider
available space for drain tubing
2. Drill 1/ 4” hole into the drainpipe above the water line of the pipe. Clean the surface of
the pipe.
3. Pear off the sticky foam pad, then align the centre hole around the drilled pipe hole.
Then tape it.
4. Align the drilled hole in the drain pipe with the drain saddle using a drill bit or narrow
screwdriver, then put the complementary piece and clamp them together with the two
bolts. Tighten the two bolts evenly.
5.
Connect Black tubing to drain saddle valve
.
Step 3: Installing the dispensing faucet
The faucet should be positioned with aesthetics, function and convenience in mind. An ample
flat surface is required for the faucet base so that it can be drawn down tight. Also check the
under sink area of the desired location to see if there is ample space to complete the faucet
installation.
If the space is not available on the upper sink area, the faucet could be positioned on the
counter top at the edge of the sink. Be sure to watch for obstructions below, i.e., drawers,
cabinet walls, support braces, etc. If the counter top is ceramic tile, the method for drilling the
hold should be the same as for porcelain sink.
NOTE: The sink drilling process, although not complicated, requires a certain amount of
caution and forethought. Porcelain sink can chip if care is not exercised.
