washloo Side Control, User Manual

Page: 7 / 21

Installation Guide
Installation Environment
1. Prior to installation, ensure the area for the Washloo is clear and the
correct model has been selected for your pan (please see online
fitting/measuring guide).
2. Washloos’ requires water pressure between 0.06Mpa (flow) - 0.75Mpa
(Static).
3. Only use mains water supply. Do not use tank fed water, industrial
water or grey water for the supply as this may cause skin damage or
disease. This may also block the filters located within the T-Piece
quickly (Hard Water Areas).
4. Use the supplied T-Valve/Filter to ensure the Washloo is correctly
protected against contaminated/hard water. In hard water areas it is
advisable to use an inline water softener.
5. ‘Do Not’ connect the Washloo to the power supply before the
installation is complete.
Installation of the T-Valve/Filter
1. Turn off water supply to your existing toilet to avoid any leaks prior to
installation (turn your nearest ‘Stop Tap’ off). Disconnect water supply to
the cistern.
2. Connect T-Valve/Filter between the water supply to your existing cistern as
shown below.
3. Reconnect the water supply to your cistern now with the T-Valve/Filter
installed in line.
Cistern
T-Valve/Filter
Turn Off
Step 1
Step 2
Step 3
Stop Tap
O-Ring
Seal
Cistern
Stop Tap
Plastic
Water Pipe
5