Set the thermostat, if present, to the lowest level. Set the flame adjustment knob to the
HI
position. Press slightly and turn the control knob clockwise
3
to the
OFF
position and
wait 5 minutes; thus allowing any gases to escape which may have accumulated in the
combustion chamber.
Note:
LP gases do not vent upward. Then follow step 2 and 3 to establish pilot.
OPERATION INSTRUCTIONS
Cont..
Press and turn control knob counterclockwise
4
to
ON
position.
Release knob. If pilot should go out, turn the control knob to
OFF
position and repeat steps
1, 2 and 3.
Note:
this will allow reset of INTERLOCK for proper lighting of pilot.
Press slightly and turn control knob counterclockwise
4
to
PILOT
position; depress
control knob and light pilot by repeatedly pressing the sparker. Venting of air may take
place at the pilot prior to the flow of fuel gases. Once flame is established, hold knob
depressed for approximately 60 sec.
START-UP PROCEDURE
1.
2.
3.
4.
5.
7.
Turn flame and heat adjustment knob to the desired comfort level from
HI
GH to
LO
W.
8.
TEMPORARY SHUT-DOWN PROCEDURE
To turn off the main burner only, set the thermostat to the lowest setting or turn
remote switch to
OFF
. Press and turn the knob clockwise
3
to
PILOT
position.
Press and turn the knob clockwise
3
to the
OFF
position.
COMPLETE SHUT-DOWN PROCEDURE
6.
Turn thermostat to the desired comfort level or turn ON/OFF switch to the ON position.
15
Flame and Heat Adjustment Knob
Sparker
Control Knob
f i r e - p a r t s . c o m
Summary of Contents for northfire dvr36h
Page 25: ...24 24 fire parts com...
