Warner Electric • 800-825-9050
P-2101-WE • CBCx-001
3
General information
Power supply enclosure should be kept clear of all
areas where foreign material, dust, grease, or all
might affect the operation of the control.
Installation must be made in accordance with the
instructions found in this manual. Failure to do so
may damage the Power supply.
Electrical Connection
1
DC BRAKE +
Power Output
Output contact to the Clutch/Brake Coil. DC Power output : 90 VDC to 450 VDC.
2
DC BRAKE -
Power Output
Output contact to the Clutch/Brake Coil.
3
SHUNT+
Accessory
Current Sensing.
Contact which allows the opening of the power supply DC Side to integrate a current
sensing or over measuring instrument. One can add a Hall effect current probe for
instance.
Default : When not used, a Short circuit bridge is needed between pins 3 and 4.
4
SHUNT-
Accessory
Current Sensing.
5
DC
Accessory
DC switching off.
Use to Power off the brake with a Fast Response Time : Emergency stop for
instance.
Default : When not used, a Short circuit bridge is needed between pins 5 and 6.
6
DC SWITCH -
Accessory
DC switching off.
7
AC
Power Input
AC power Input : 90VAC to 500VAC
8
AC
Power Input
AC power Input : 90VAC to 500VAC
9
PE
Protective Earth
This terminal is usually connected to earth provided by the AC grid.
Logical
Control
1
ON/OFF +
Digital input
Logic Control. 24V PNP input. When High, powers up the brake. This power up will
be made on the AC side, with offering
If over-excitation feature is enabled, then over-excitation voltage is applied during the
programmed time.
Active High/GND: PNP type Input.
Logical
Control
2
Ground
Digital input
Ground
