©2016 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
7
98178B0
13. Reinsert plastic nut (both sides) back into the inner fender
well.
14. Reinstall the screw removed in step 4 (both sides). This is
how it will look after the plastic is cut.
15. From underneath vehicle, remove the bolt just outside of
tow hook (both sides). It will be the bolt that holds the stock
frame insert piece to the vehicle. Keep bolt as you will be
reusing them to attach bumper supports.
Do not remove the
tow hook bolts.
16. Before installing frame bracket you will need to cut out a
small notch in the plastic air shroud.
a. Hold frame bracket in place and mark area on shroud
to notch (enough to clear the frame extension bracket).
Carefully cut notch and fit up bracket.
b. Slide new frame bracket over the three bolts left where
you removed the aluminum frame extensions and
lightly hold into place using the factory nuts in step 7.
Leave nuts loose at this time to allow for adjustment.
Figure 13
Figure 14
Inside view of screw hole
intact with plastic nut
and screw reinstalled
Remove
Figure 15a
Install
Figure 15b
Notch
