©2016 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
6
98178B0
9. Your vehicle should be stripped down to look like this.
10. Run a tape line down each side of the body plastic profile
that use to hold the factory front facia plastic piece you
removed in step 2.
11. Use the outside of the front facia outline and the inside of
the tape line as your cut line.
Be careful as to not cut inner
fender.
NOTICE
Avoid cutting the screw holes on each side and
bottom of body plastic, as they will be reused.
WARNING
Always use extreme caution when cutting and trimming during
fitting. Make sure that all fuel lines, brake lines, electrical wires, and other objects
are not punctured or damaged when cutting on the vehicle. Thoroughly inspect the
area to be cut (on both sides of material) prior to cutting, and relocate any objects
that may be damaged. Failure to inspect the area to be cut may result in vehicle
damage, electrical shock, fire or personal injury.
12. After front facia is cut out completely, cut along plastic fog
lamp plastic bracket. Follow along the edge of bracket. The
fog lamp and plastic bracket will come out as one assembly.
* Figure 12 shows completed removal of plastic cut.
Figure 9
Figure 10
Cut line
Screw hole intact
Cut along edge of
light bracket
Figure 11
Figure 12
