WARN® INDUSTRIES
PAGE 7
79816A5
V. Operation
Attaching the plow to the vehicle
1. Stage the plow assembly on level solid ground.
See Plow operator guide “Installing the Plow” for
more information.
2. SLOWLY drive the vehicle up to the plow assem-
bly with the vehicle as square to the plow as pos-
sible.
3. Turn off the vehicle and set the parking brake.
Lift the plow mount flange end of the push tube
assembly up to the plow mount on the vehicle.
Insert the plow mount flange into the plow mount
receiver. See Figure 12.
4. Double check that the plow is fully engaged with
the alignment pucks on the plow mount flange.
The alignment pucks should be fully seated into
the plow mount cradle feature.
5. With both alignment pucks seated into the plow
mount the retaining pins can be inserted. Once
inserted the retaining clips on the pins can be
clipped onto locking tab on plow mount. See Plow
operator guide “Installing the Plow” for more infor-
mation.
6. With both retaining pins secure, pull out the line
from the winch.
7. Pull the retaining pin on the plow assembly that
is securing the pulley assembly. With the pulley
assembly loose, place the pulley assembly over
the winch line and reinstall the pulley assembly
onto the push tube assembly securing the pulley
assembly with the retaining pin. See “Double Line
Rigging” in the Plow Lift section of the Plow Op-
erators Guide.
8. Connect the termination strap to the front bumper.
The loop of the strap should be place as high as
possible on the bumper. See Figure 13. See Fig-
ure 15 when connecting to a WARN front brush
guard.
Figure 12
Figure 10 Install Fasteners
Figure 11 Install Plow Mount Flange
B2,B9,B10
A3
