©2021 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
7
108765A0
I N S T A L L A T I O N I N S T R U C T I O N S
Drill out
Tech Tip: Drill out the upper outer corner holes (where you
removed the last two torx screws) to a slightly larger size for
ease of installation later on.
WARNING
Always verify area is clear of fuel lines, fuel
tank, brake lines, electrical wires, etc., when drilling.
15. With assistance, lift the winch mount assembly in to the
position of where the skid plate was mounted.
16. While holding the mount in place, install one of the
previously removed Torx head screws back into the
threaded nut clip/tab of the mount to temporarily hold
in place.
17. Thread one M8 X 25mm long bolt (B3) through the
vertical frame upright (
where you removed the bumper
bolt in step 5
) and into the weld nut on mount.
Do not
tighten completely to allow for adjustment.
18. Repeat for other side. Refer to exploded view on page
3.
Torx bolt
Winch Mount
B3
Figure 11
Figure 10
Figure 12
