©2016 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
6
106448A0
10. Place the new bumper mount (A1) into position.
11. Line up the bumper mount mounting holes with the vehicle
mounting holes and secure to the front of the vehicle using
the four factory hex head bolts.
12. Secure each top corner of the bracket to the vehicle using
one M10 bolt (B1) and nut (B2).
TIP: Use a 15mm socket on
the front of the bolt and a 17mm wrench on the rear nut to
make this install a little easier.
13. Replace the trimmed plastic fascia over the mount and
snap back into position.
NOTE: The slots you trimmed in
the plastic should align with the bracket to allow enough
clearance for the plastic to sit in its original position.
14. Reinstall the two side factory torx head screws (each side).
15. Slide the bumper shell over the D-ring loops in mount and
align mounting holes.
16. Install your fairlead to the fairlead plate (A3) using hardware
supplied in the winch kit.
A1
Figure 6
Figure 8
B1 & B2
B1 & B2
Factory bolts
Figure 7
