©2019 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
6
106092A0
I N S T A L L A T I O N I N S T R U C T I O N S
10. Remove the upper plastic fascia from bumper support by
pulling upward and out.
TIP: You may need to use pliers to
assist with depressing the clips that hold plastic in place.
11. Remove the lower plastic trim by removing the two
plastic clips on the bottom edge and the six hex head
bolts.
NOTE: Image shows plastic already removed for
clarity.
12. Remove the four torx bolts on each wing of the bumper
Retain bolts for later install.
13. Remove the three hex head bolts securing each wing
to the inner bumper support to remove the wing
completely (each side).
Retain bolts for later reinstall.
14. Remove the two clip nuts on each wing.
Remove
Remove
Clips
