©2019 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
7
106092A0
I N S T A L L A T I O N I N S T R U C T I O N S
15. Install one wing clip to the inner side of the stock
bumper structure (each side).
16. Install the remaining clip to the new bumper’s lower tab
(each side).
17. If equipped, install the four sensor harnesses into
the bumper.
NOTE: Keep in the same location and
orientation as they were in the stock bumper.
NOTE: If not equipped with sensors, use supplied plugs
(A1) to cover holes.
18. Place the license plate light housing into the new
bumper.
19. Mark the housing where the slot on the bumper mount
tab is aligned.
20. Remove the housing and drill a hole in the marked
location using a 3/16” bit.
21. Reinstall the housing and secure using the supplied
hardware (A4 & A5).
Install clip
Install clip
Sensor harness
location
Mark
Housing
