“advanced settings”
•
WARNING!!
The options in this section can affect the perform-
ance of your thermostat and should only be modiied by an experi-
enced underloor heating installer or under the instruction of War-
mup technical support.
DISPLAY / AUDIO
“theme”
• Change the content and style of home screen and standby screen
“standby brightness”
• Set the brightness of the LCD screen in standby mode between 0
(dimmest) and 5 (brightest)
Note
: when set to 0 the LCD screen will turn OFF and the “wake”
LED will not be illuminated. You will need to remember that you turn
the screen on by pressing “ ”
“display brightness”
• Set the brightness of the LCD screen in normal operation between
1 (dimmest) and 6 (brightest)
“heating indication”
• This feature allows you to turn off the heating indication LED (top
right of the LCD screen). The thermostat will continue to operate
as normal but the LED will not turn on to indicate when heating has
started and stopped.
“audio feedback”
• This feature allows you to turn off the beep sound made when a
button is pressed
“child lock”
• Child lock creates a delay between pressing “wake” and exit-
ing the standby mode. When child lock is on you will need to hold
“wake” continuously for 10 seconds in order to exit standby mode.
SET HEATING TARGET
Your thermostat is capable of using a loor temperature sensor, air tem-
perature sensor or both for thermal regulation. If you are using your
underloor heating as secondary heating source (such as in the bathroom)
then you might prefer to use the loor temperature. However if the under-
loor heating is the primary heating source in your home you might prefer
to use the air temperature.
“set loor temperature”
• Thermostat will use the temperature reading from the loor sen-
sor to decide whether heating is required to achieve the target set
temperature
“set loor temperature with air limit”
• Thermostat will use the temperature reading from the loor sen-
sor to decide whether heating is required to achieve the target set
temperature, however if the air temperature goes above the set limit
then heating will be suspended until air temperature falls below limit
“set air temperature”
• Thermostat will use the temperature reading from the air sensor
(inside thermostat housing) to decide whether heating is required to
achieve the target set temperature
Hint
: if you change the heating target settings then it is advisable to
re-program your thermostat to ensure that the program still meets your
needs.
