29 March 2021
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
All Dimension are in mm
………….
Copyright ©
14
Your Fire must be Installed and Tested by a suitably qualified Gasfitter prior to use.
To light:
•
Open
the front cover by pulling in outwards.
•
Push in the ignition control switch and hold in the
‘
PILOT
’
position for 5
-
10 seconds until you can hear
the gas come through the pipe –
making sure the ignition switch is pressed in firmly.
•
To strike the igniter, turn anti clockwise to the
* STAR
position (
w
ith the ignition switch still firmly
pressed in
)
until you hear the pilot ignite with a
‘
click
’.
Repeat this process 2 or 3 times if necessary.
•
Once the pilot flame is lit, hold this position for 3
-
5 seconds, then gently let the ignition switch out, and
set the flame control to high.
It may take a few seconds for the burner to light all the way across.
•
Once the flame is established, adjust to the desired setting and close the
cover.
To shut down:
•
Open the cover by pulling it outwards.
•
Turn the control ignition switch to
‘
PILOT
’
and the flame bed will extinguish.
•
Pilot light may be left on and the pilot flame will still burn.
•
To fully extinguish, turn to the
‘
OFF
’
position before closing the cover.
Locate the three self
-
tapping screws provided into the under
-
side of the top ledge of the firebox
Remove the backing tape from the adhesive Velcro pads at the bottom of each fascia side
Offer the fascia into position locating the three screws into their associated slots
-
tighten screws
Apply firm pressure to the bottom edges to bond the Velcro tape
The fascia may be removed at any time by loosening the screws and parting the Velcro
.
Please refer to additional sheet for Burner Ratings and Frame
-
out details.
FASCIA KIT (Black or Stainless Steel)
OPERATION OF YOUR WARMINGTON GAS CONVECTION FIRE (SG ONLY)
Note:
Fascia is fitted at the end of the
installation process and may be
after the wall and surroundings
have been completed.
