Miscellaneous—Carrier
AM24480,00000F2 -19-22AUG14-1/1
Using Booster Batteries: TimberRite™
Before boost starting, the machine must be properly shut
down to prevent unexpected machine movement when
the engine starts.
CAUTION: An explosive gas is produced while
batteries are in use or being charged. Keep flames
or sparks away from the battery area. Make sure
the batteries are charged in a well-ventilated area.
IMPORTANT: Short circuiting or using booster
batteries above 140 amp without first
disconnecting the controller will damage
it. Always disconnect the controller before
using booster batteries, otherwise severe
controller damage will occur.
NOTE: For TimberRite™ controllers, turn off
the key-switch.
1. Turn off the carrier main switch and the TimberRite™
controller key-switch.
2. Disconnect the TimberRite™ power connector (1).
3. Disconnect the CAN 1 connector (3).
4. Connect one end of the positive cable to the positive
terminal of the machine batteries (A), and the other
end to the positive terminal of the booster batteries (B).
5. Connect one end of the negative cable to the negative
terminal of the booster batteries. Connect the other
end of the negative cable to the machine frame, as far
away from the machine batteries as possible.
6. Start the engine.
7. Allow several minutes before you disconnect the end
of the negative cable from the machine frame. Then,
1
3
XJ1
162926
—UN—1
1JUN14
TimberRite™ Controller Module
T7233JN
—UN—21MA
Y90
1— Power connector
3— CAN 1 connector
A—Machine batteries
B—Booster batteries
disconnect the other end of the negative cable from
the negative terminal of the booster batteries.
8. Disconnect the positive cable from the booster
batteries and machine batteries.
9. Connect the CAN 1 connector (3).
10. Connect the power (1).
TimberRite is a trademark of Deere & Company
4-1-8
053122
PN=87
