Williams & Hussey
www.williamsnhussey.com
20
INSTALLING FEED ROLLS
1.
Follow Steps 1-5; Removing Feed Rolls.
2.
When installing the axles the feed roll should be inside the swing arm casting. NOTE: Proper
placement of axles and orientation of swing arms is critical. Refer to illustration below.
3.
Each roll has a shallow hole in one side and a deep hole in the other. There is a reamed
section at the end of each hole. The P-122 short axle end has a ¼” depth reamed section.
4.
Install the P-122 short axle in the ¼” depth reamed section using thread locker. Install the
P-124 or P-224 axle in the deep reamed hole. NOTE: P-122 should be installed using thread
locker, P-124 & P-224 do NOT use thread locker.
5.
Place the P-124 or P-224 axle in a vise with the flat on the shaft against one of the vise. The
roller will be standing up vertically.
6.
Put a couple drops of thread locker on the P-122 axle and insert the axle into the swing arm
casting and roller and screw in the axle loosely tightly. Grasp the roller with both hands and
tighten it against the P-124 or P-224 axle. Go back and finish tightening the P-122 axle as
hard as you can.
7.
Replace the P-111 sprocket on the P-124 or P-224 axle.
8.
54-505 Infeed Swing Arm Assembly Installation:
●
Insert the 54-505 Infeed Swing Arm Assembly into the 54-2 Rev A head casting from the
underside of the head casting.
●
Install the 54-505 assembly up and over the 54-16 rest pin.
●
Engage the P-155 short chain onto the P-111 sprocket.
●
Install the (2) 54-15 pivot screws using a couple drops of thread locker.
●
Double check to see that the chain is properly engaged on the P-111 sprocket.
9.
54-506 Outfeed Swing Arm Assembly Installation:
●
Insert the 54-506 Outfeed Swing Arm Assembly into the 54-2 Rev A head casting from the
underside of the head casting.
●
Install the 54-505 assembly up and over the 54-16 rest pin.
●
Engage the P-156 long chain onto the P-111 sprocket.
●
Install the (2) 54-15 pivot screws using a couple drops of thread locker.
●
Double check to see that the chain is properly engaged on the P-111 sprocket.
10.
Install the 54-25 pressure screws, 54-26 spring guides, 54-24 REV A roller pressure springs
and the 54-51 check nuts.
