Wanco WI3000P, Operator'S Manual

Page: 14 / 28

Page | 12
The neutral conductor in this generator is bonded to the generator frame (“bonded neutral”). Follow
local codes regarding grounding of portable generator sets, depending on how it is used.
The total wattage of all appliances connected must be considered.
Do not exceed the current limit specified for any one receptacle.
Do not exceed the total power available from the generator.
When an extension cord is required, make sure you use the proper size and length.
•
16 gauge cords up to 100 feet long will adequately handle loads up to 10 amps.
• 14 Gauge Cords up to 50 feet long will adequately handle loads up to 15 amps.
•
12 Gauge Cords up to 100 feet long will adequately handle loads up to 15 amps.
Start the engine and make sure only the output indicator light (green) comes on.
Confirm that the appliance to be used is switched off, and plug in the appliance.
Before connecting an appliance to the generator, check that its electrical
rating does not exceed that of the generator.
Be sure that all appliances are in good working order before connecting them to the generator. If an
appliance begins to operate abnormally, becomes sluggish, or stops suddenly, turn off the generator
immediately. Disconnect the appliance and examine it for signs of malfunction.
Turn on the appliance and observe the generator for any abnormal operation.
When an electric motor is started, both the overload indicator light (red) and
the output indicator light (green) may go on simultaneously. This is normal
but if the overload indicator light (red) stays on more than about four seconds, consult a service
center.