Page | 11
GENERATOR USE
Starting the Engine:
When starting the engine after adding fuel for the first time, after long term storage or after running
out of fuel, turn the fuel valve lever to the "ON" position, then wait for 10 to 20 seconds before starting
the engine.
Turn the combined engine switch / fuel valve to the ON position.
Pull the choke knob out to the START position.
Do not use the choke if the engine is already warm or the ambient air
temperature is high.
Insert the key into the Start Switch on the panel
Electric Start: turn the control panel switch to the START position (full clockwise) until the engine has
started, then release. Do not engage the starter for more than 10 seconds. If the engine does not
start, wait 10 seconds before attempting another start.
Manual Start: pull the starter grip lightly until resistance is felt then pull the starter grip briskly toward
the arrow as shown below. Do not allow the starter grip to snap back. Return it slowly by hand.
Push the choke lever in to the RUN position as the engine warms up.
If the engine stops and will not restart, check the engine oil level before
further troubleshooting.
Shutting Down the Engine.
To stop the engine in an emergency, turn the engine switch to the OFF (O) position.
1. Switch off the connected equipment and pull the inserted plug out.
2. Turn the engine switch to the OFF (O) position
Connecting Loads to the Generator.
Never connect a portable generator directly to any building service wiring
through an installed receptacle. “Backfeeding” creates a risk of severe shock
for the user and for utility personnel who may be working on power lines.
DO NOT connect a Wanco inverter generator to a building through a Double Throw Transfer Switch
as it may damage the inverter. Only connect loads directly to the generator using extension cords.
Limit operation at maximum power to 30 minutes or less.
Summary of Contents for WI3000P
