5.0 INSTALLATION AND FIXING
SILOTOP R03
2
FIL.100.--.M.EN Issue: A2
06.12
41
5.9 Inspection
Important
When installation is complete, authorized personnel must carry out a general test to ensure that the
safety conditions have been completely satisfied.
The authorized personnel must also check:
- that no tools or other material have been forgotten inside the filter;
- that the fixing screws have been tightened using the prescribed torque;
Before starting to operate the filter:
- Ensure that the plant in which the filter is installed is compliant to the Directive 2006/42/EC and to the rel
-
evant general directives and safety standards in force and those specifically applicable.
- Ensure that the inspection hatches are locked with the bolts supplied inserted in their original position.
- Ensure that the operating conditions are met.
5.10 Commissioning
Preliminary checks
After completing the electrical and compressed air connections, carry out the following checks:
- Check to ensure the controller board is powered and set correctly.
- Ensure that the pressure of the filter reservoir is 6 bar.
- Check all nuts, bolts and locking devices to ensure they are perfectly tightened.
- Check all elements to ensure they are fixed properly to the seal frame.
- Check the seals to ensure they are not damaged and the inspection hatch is closed.
- Ensure that the warning and instruction signs are present.
- Check piping connections to the filter (if these are present) to ensure they are secured and assembled care
-
fully.
Jamieson Equipment Company | 5314 Palmero Court | Buford, GA 30518 | 800.875.0280 | [email protected]
