Rev. 1.0
WALTHER Temperature Controller Bundle WTRB-x-x
Page 8 of 42
Walther Systemtechnik GmbH
– D 76726 Germersheim
Telefon: +49 (0)7274-7022-0 Telefax: +49 (0)7274-7022-91
http://www.walther-2000.de
4 Transport
4.1 Packaging
The device will be prepared by
Walther Systemtechnik GmbH
for a transport to the first destination.
The type of packaging depends on the individual mode of shipping. If not separately contracted, the packaging
is in accordance with the rules and regulations of
Walther Systemtechnik GmbH
. This rule is in accordance with
the Federal Association for Packaging HPE.
The packing unit will not be exposed to any additional strain. Packaging and contents will be protected against
any kind of humidity. The temperature for transport and storage will strictly range between
–20°C and + 40°C.
4.2 Transport
The actual transport of the device and its individual parts requires special care in order to prevent damages from
external forceful impact or careless on- and off-loading. Depending on the mode of transportation, suitable
transport and load securing has to be selected. The device will be aligned and leveled by appropriate fastening
elements.
4.3 Damages in Transport
The following will be observed when the receiving checks reveal damages in transport:
•
Contact the carrier (carrier, train etc.)
•
Write a protocol of damages
•
Contact the supplier
4.4 Location of Set-up
•
All legal requirements for the mounting site should be clarified and fulfilled.
•
Prior to installation of the equipment, the condition of the floor and the size of the surrounding space
should be checked to ensure safety of operation for both personnel and equipment. The installation must
be such that continuous operation at a high safety level is ensured.
•
The installation of the equipment as well as commissioning or storage of the equipment must be con-
ducted by specialists that are trained and made familiar with the equipment only.
•
The equipment is designed for use in areas which are protected from climatic conditions.
•
Operation or storage of the equipment in an aggressive or moist environment or outdoors may lead to
corrosion or other damage for which
Walther Systemtechnik GmbH
will not assume liability.
•
All exposed parts and lines must be mounted as such that no injuries or damage can occur
•
The minimum allowed space around the device will be closely observed.
