Auxiliary Battery Kit w/Dual Cables
80101569
Page 2 of 6
Cut cables to required length.
Use remaining length of cables to connect from auxiliary
batteries to vehicle batteries (for truck applications only,
trailers will use additional 0 ga. cables).
Install terminal lugs on ends of cables as shown below.
Protect wires from any sharp edges or
holes that may abrade insulated covering
of wires.
Secure battery cable so it does not come
near, or in contact with, other vehicle
wiring, fuel lines, brake lines, air hoses,
exhaust system, etc.
Install cable lugs as shown below.
GR01961
INSTALLATION OF TERMINAL LUG
Strip 7/8” to 1” of insulation from end of cable.
Slide heat shrinkable tubing onto cable.
Insert bare wire into compression nut until it seats.
IMPORTANT:
Be sure to use correct compression
nut, use 1&2 gauge nut for 1 gauge
cable, use 0 gauge nut for 0 gauge
cable.
Note: Copper wire should be flush with, or slightly past
nut
7/8” to 1”
Heat shrinkable tubing
before installation
GR00299
Grip nut with wrench and turn terminal until nut seats
GR00300
AUXILIARY OR VEHICLE
BATTERIES
Compression Nut
37
Summary of Contents for GT-33
