32
33
7. Power supply
7.1 Battery power supply - battery installation
• If the battery isn´t yet inserted, unscrew the cap of the handle/battery compartment.
• Insert the supplied battery (17) WITH THE CONTACTS UP into the battery
compartment. With light pressure, turn the battery until the end of the battery
fits with the handle.
• Check the correct position of the battery.
• Close the cover of the handle / battery compartment (14) again.
• The device is ready for use.
7.2 Charging the battery
Please note that the Walimex pro Ice Sword 300 light can not be supplied with
power for continuous operation via the battery charging socket of the device. The
operation is done exclusively by battery. Therefore, always charge the battery early
enough.
• Insert the battery into the battery compartment in the handle as described in
section 7.1.
• Connect the round cable of the battery charger (19) to the battery charging
socket (8,4 V, 2 A) (12) on the device.
• Connect the plug of the power adapter into the socket of your local power
supply (AC 100-220-240 V / 50-60 Hz).
• The device starts charging automatically.
• Disconnect the charger from the lamp after charging
• If the LED lamp is not used for a long time, remove the battery from the battery
compartment of the handle.
Recommendations for using your battery.
• Change the battery, at the latest, when the light starts to fl icker
• Switch the device off before removing the battery.
• This also applies for changing or adding another battery in models with several
battery mounts. Switch the light off before adding or changing the battery, and do
not insert other batteries into the mount while the light is being used.
• Do not let the battery charge level go too low, and charge up your battery as
soon as possible. This ensures the longer battery life.
• Please remove the battery from the battery mount while transporting or storing
the device. This is to prevent damage to the battery mounts during transportation
and prevents the battery becoming uncharged unintentionally.
• To maintain the performance of your battery, we recommend letting the battery
run down completely and then recharging it around once a month.
• Please remove the battery from its mount after using your device
WARNING
Precautions when using with rechargeable battery
These can run out or explode, if inappropriately handled. Please observe the fol-
lowing safety notes when handling the rechargeable battery for use with this unit:
■
Use only rechargeable batteries mentioned in these operating instructions.
■
Do not lay the rechargeable battery into fire or expose these to direct heat.
■
To prevent the product from being damaged make sure you have removed
the rechargeable battery if you will not use the product over a longer period of
time or if the rechargeable battery has been discharged.
■
If battery fluid has come into contact with skin or clothes, flush it off immedia
-
tely with fresh water.
■
Do not recharge the rechargeable battery unattended.
■
Once the reacharging process is finished, disconnect the charger from the
power supply.
NOTE
Only use batteries intended for the device – see technical specifications. After
use remove the batteries from the battery compartment.
NOTE
Compare the local electric power supply with the connection values of the
device. Should the connection values not match, please contact [email protected].
NOTE
Only connect the power supply unit to an earthed plug.
NOTE
After use, disconnect the device from the local power supply by simple pulling
out the mains plug.
