38
39
Remote control
does not work
No batteries inserted
Insert batteries
Device ist switched off via
power switch
Switch on the device with the
ON/OFF switch
Wrong channel selected
Make correct channel selection
The device is defective
Contact our service! Repairs
may only be done by a quali-
fied electrician
• Set the dimming mode, the red status LED lights up.
• The brightness value currently set on the remote control is displayed in % on
the remote control display.
• Set the desired light output by pressing the plus <+> and minus <-> buttons
on the remote control. The values on the lamp are automatically synchronized
with the settings of the remote control if a new value is set for the first time.
• The brightness changes and the selected values are displayed on the remote
control display.
9. Transporting, storing the device
WARNUNG
Danger of fire caused by hot parts of the equipment. Allow the device to cool down
completely.
• Switch off the device (See „Switching the device on, off).
• Allow the device to cool down completely.
• Unplug the power supply cable from the device.
•
If necessary clean the device (See „Cleaning the device“).
• Lay the device and all disassembled elements into the original article packaging
box and transport of store as specified in the technical specifications. See techni
-
cal specifications.
10.Troubleshooting
Problem
Possible cause
Remedy
The device is
switched on, but
does not show any
function.
No batteiy installed
Install the battery
Battery inserted wrong
Insert the battery correctly
Battery is
exhausted
Charge the battery
The illuminants
does not light“
Device ist switched off
Switch on the device
The device is defective
Contact our service! Repairs
may only be done by a quali-
fied electrician
11. Maintaining the device and cleaning
WARNING
Danger of electric shock and danger of fire due to short circuit.
Have the device repaired by an electrician immediately.
WARNING
Danger of cutting and splintering caused by bursting illuminant
Cleaning
WARNING
Danger of electric shock
■
Do not bring the device into contact with moisture or water.
■
Always pull out the power supply plug before starting to clean the device.
Device
Cleaning
Housing
Use a microfiber cloth to remove light and stubborn dirt.
Illuminant
Clean off dirt with a dust brush or a dry, soft cloth.
NOTE
Do not clean the illuminant with water. Even slightest residues on the
illuminant can cause bursting of the illuminant.
