7
•
Mount the enclosed ball valve in the opening provided (see photo).
•
Note that the seal is mounted on the outside!
•
The recommended torque for the assembly is 20 Nm.
6.1. Additional maintenance
Check the lip seal every week for damage and replace if necessary.
We generally recommend replacing the seal after a maximum of 3 years. Use only original replacement seals from Walpol
Instructions for replacing seals:
Pull off / remove old seal
Attach a new seal according to the pictures below
Apply the enclosed silicone all
around the entire edge
Put the lip seal on the edge all
the way to the around and to
the starting point
Cut off at the overlap point
Remove excess silicone, put
the cover back on firmly and
close the quick-release faste-
ners
7. Regulations / rules
If the machine is operated outside of Germany, the safety regulations in the country of use are also relevant.
Relevant regulations and rules must be observed:
•
Accident prevention regulations
•
Other generally recognized safety, occupational medicine and road traffic regulations
Important
Observe the rules for safe and professional work
In addition to the operating instructions and the accident prevention regulations applicable in the country of use and at
the place of use, the recognized technical rules for safe and professional work must also be observed.
The permissible loads on the grease separator system must not be exceeded!!
After filling up with fresh water, the device can be put into operation. Only wastewater with vegetable and animal fats or oils
may be fed into the grease trap. (A mixing of fats from grease separators with other organic fats, e.g. from deep fryers, is
strictly prohibited.)
The fat that has accumulated must be skimmed off daily, collected in an odor-proof container and properly disposed of -
proper function through timely fat removal.
7.1. Foreseeable misuse
The grease separator may only be operated by someone who has read and understood the operating manual.
People who are under medication or other drugs are not allowed to operate or maintain the system or carry out other acti-
vities on it.
7.2. Liability
With the machine acceptance, the operator confirms that the supplier has fulfilled all due diligence obligations within the
scope of what is possible and reasonable.
We are liable for defects in the delivery according to the conditions agreed in the order confirmation.
The rectification of defects may only be carried out by qualified personnel.
Our liability is limited to damage caused by normal use.
We are not liable for security deficiencies that are not yet recognizable according to the current state of technology.
7.3. Recommendation
•
Components and accessories are designed exclusively for this product.
•
When purchasing spare or wear parts, only original parts are to be used.
•
We expressly point out that parts and accessories not supplied by us have not been tested and approved by us. The
Summary of Contents for WNG-1
Page 16: ...ww eu...
