Wallenstein BXTR5224, Operator'S Manual

Page: 33 / 68

BXTR5224
Trailer Wood Chipper
Operating Instructions
33
5. Operating Instructions
CAUTION!
Hearing loss hazard. Prolonged
exposure to loud noise may cause
permanent hearing loss. Use suitable
protection while operating the
machine.
W016
The operator has the responsibility of being familiar with and
following all operating and safety procedures.
When operating this equipment always have at least two
workers present and trained in safe operation of the machine.
Although this machine is easy to use, each operator should
review this section to get familiar with the detailed safety and
operating procedures.
5.1 Before Startup
1. Check the engine oil level. See page 35.
2. Check the hydraulic oil level. See page 35.
3. Open the fuel valve. Check the fuel level. See page 36.
4. Check the engine air cleaner. See page 49.
5. Review the Safety Rules on page 8 .
6. Clear the area of bystanders, especially small children.
7. Make sure each operator is trained and familiar with the set
up and operation of the wood chipper.
8. Perform the Pre-operation Checks.
9. Review the Controls (see page 21 ).
10. Survey the work site and place the chipper in a clear, level
work area.
11. Set up the machine correctly. See Machine Setup page
36 .
5.2 Pre-operation Checks
Check the following each time the wood chipper is used:
Pre-operation Checklist
Check the machine has been lubricated
following the schedule outlined in the
Maintenance section.
Check the tension and alignment of the belts.
Adjust as required.
Check the rotor housing and discharge chute.
Remove any blockages, twine, wire or other
material that has become entangled.
Check the condition and clearance of the twig
breaker, rotor and stationary blades. Adjust or
replace as required.
Check condition of the battery and other
electrical components. Keep all components
in good condition.
Check for hydraulic leaks. Tighten
connections or replace components to stop
leaks.
Check and ensure that all covers, guards
and shields are in place, secured, and can
function as designed.
Check that all bearings are properly greased.
Replace if they do not turn freely.
Check and inspect tires, wheels, and hubs.
Check hydraulic fl uid level. Top level up as
required.
Check and tighten all fasteners. Make sure
the equipment is in good condition.
Check that appropriate equipment for
personal protection is available and being
used.
Check that jewelry, loose-fi tting clothing are
not worn. Make sure long hair is tied back.