Wallenstein BXTR5224, Operator'S Manual

Page: 35 / 68

BXTR5224
Trailer Wood Chipper
Operating Instructions
35
5.5 Engine Oil Level Check
Check engine oil level daily. Check with the machine parked on
level ground and the engine stopped.
IMPORTANT! Running the engine with a low oil level can
cause engine damage that is not covered by warranty.
1. Remove the oil level dipstick and wipe it clean.
2. Fully insert the oil level dipstick, then remove it to check the
oil level.
3. If the oil level is low, remove the oil filler cap and add oil
until the level is at the FULL mark on the oil level dipstick.
SAE 10W-30 or 5W-30 is recommended for general use.
4. Reinstall the oil level dipstick and oil filler cap.
00172
1
2
Fig. 32 –
Checking Engine Oil Level
1. Oil Filler Cap
2. Oil Level Dipstick
Refer to the engine owner's manual included in the manual
tube for further information on engine oils.
5.6 Hydraulic Oil Level Check
Check hydraulic oil level daily. The hydraulic oil tank is located
on the front of the machine. There is a sight glass on the tank to
view oil level.
Check with the machine parked on level ground and the engine
stopped.
The proper level is when the oil is visible in half the glass
window.
If the level is not visible in the sight glass, add oil.
1
2
00139
Fig. 33 –
Hydraulic Tank Oil Level Check
1. Hydraulic Tank Filler Cap
2. Oil Level Sight Glass
IMPORTANT! Do not operate machine if oil level is not
visible in the sight glass. Damage to the pump and other
components can occur.
Do not overfill the tank past the sight glass window.
IMPORTANT! Hydraulic oil quality should be inspected
every 50 hours. If the oil is dirty or smells burnt, it should be
replaced.
IMPORTANT! Be aware of high oil temperatures.
Temperatures higher than 180 °F (82 °C) could cause seal
damage and degrade oil quality.
5.6.1 Adding Oil to the Tank
The hydraulic system uses Dexron® III ATF .
1. Clean the area around filler cap and remove it.
2. Use a clean funnel and add oil until the level fills half of the
sight glass window.
3. Install filler cap securely. Wipe up any spilled oil.
Check levels after changing filters or servicing hydraulic
components.