07.11.2017
16
EXERCISE AND PLAYING TIPS:
Regular playing and exercising on the SET lead to improvement of general physical conditions of a child (posture, appetite,
sleep).
•
To develop strength and physical dexterity the following exercises are recommended:
o
on the vertical ladder
–
climbing up and down the ladder, abdominal press exercises;
o
on the climbing rope - pulling up on hands, climbing up along the rope;
o
on the rings
–
pull-ups, front (back) handspring, abdominal press exercises.
•
Exact types of exercises, volume and intensity of workload must be determined by adults upon consulting with the specialists (doctors,
sport trainers, etc.).
In case of non-compliance with the safety measures and guidelines for the operation of the SET a child can be injured!
10. INSTRUCTIONS FOR CHECKS AND INSPECTIONS ON BEFORE OPERATION
The following procedures should be done before using the SET:
•
Visual inspection of the SET;
•
Structural integrity check: make sure that all the components are installed and attached properly.
Failing to perform inspection and examination of the SET may lead to falling or turning over!
11. INSPECTION AND MAINTENANCE INSTRUCTIONS
11.1 Perform visual inspection of the SET each time before using the SET:
•
Check the attachment points. If the attachment points are loose, tighten those using standard tools.
Attention!
It is strongly prohibited to unscrew the crossbar bolts.
•
Check the stability of the joints and supports of the attached equipment made on base of ropes, and cords. Check the integ-
rity of ropes and cords, the absence of wear and damage of fibers of ropes and cords.
•
Check the integrity of wooden parts of the attached equipment.
•
Make sure that the plastic protection caps are installed onto the fastenings.
•
Make sure that the SET and the ladder are installed steadily and firmly.
11.2 Perform functional inspection of the SET once a month. Make sure that the SET is installed steadily and the attachment points are
fastened firmly. Check for displacement of the SET elements: compare the initial position and the current position. Tighten all the screws.
11.3 Perform annual basic inspection.
Replace all the broken component elements with the equivalent original parts produced by the SET Manufacturer.
Replacement of the broken parts by non-original components is dangerous and therefore prohibited.
