12
Operation
Oven Pilot Ignition
This oven is fitted with a pilot as a standard option and flame
failure protection, which is incorporated by way of a thermo-
electric system for main burner. Flame failure protection will
shut off gas supply to burner should pilot burner go out, so that
un-burnt gas is not expelled.
This is an important safety
feature which is slowly becoming law throughout the
world
.
1.
Open oven door.
2.
Depress oven gas control knob and rotate anti-clockwise to ‘PILOT’ position.
3.
While holding oven gas control knob depressed, press piezo ignition button to ignite pilot burner.
Repeat Items 1 and 2 until pilot burner is lit.
4.
Release gas control knob approximately 10-20 seconds after lighting pilot.
5.
Pilot should now remain alight - if not, repeat Steps 2 to 3 above.
6.
Ensure pilot burner is alight by opening pilot viewing covers and looking through pilot burner viewing
holes in cast oven sole plate.
NOTE: Ensure that pilot viewing covers are closed once pilot is lit.
Oven - Main Burner / Thermostat
1.
Ensure oven door is closed.
2.
Turn ‘ON’ electrical power at mains supply, (green) power indicator light will illuminate on oven
control panel.
3.
With pilot burner alight, depress and rotate oven gas control knob to 'Main Flame' position. (This
puts gas valve in 'Stand-By' position and control of main burner is now carried out through oven
thermostat control).
4.
Turn oven thermostat to desired oven temperature setting required, this will regulate gas supply to
oven main burner.
5.
Oven fan will start up and oven main burner will ignite.
6.
Amber heating indicator light will show oven main burner is ‘ON’ and oven is heating. When amber
heating indicator light goes out, oven has reached pre-selected temperature, burner will cycle ‘OFF’.
Oven Fan
1.
Fan is operational only when oven thermostat is set to a temperature. Fan is controlled by a
microswitch which in turn is controlled by opening and closing oven door. Oven fan is operational
only with oven door closed.
Turning the Oven to ‘Standby’ (Pilot ‘ON’ Only)
1.
To turn ‘Off’ oven main burner / heating, set oven thermostat to '0' temperature position, this will
turn oven main burner ‘OFF’, but will leave oven pilot burner ‘ON’.
2.
In this position pilot burner will remain alight, but oven main burner will not operate until thermostat
control knob is set to a temperature.
3.
If oven pre-heating is required, set thermostat control knob to temperature 190°C and allow 20
minutes before cooking in oven to allow oven to warm up.
Pilot Burner
Viewing Holes
Sole Plate
Fig 4
Pilot Burner
Inspection Covers
DO NOT USE aluminium foil or trays directly on cast iron
sole plate(s). NEVER block or cover openings on each
side of sole plate(s).
! IMPORTANT
Summary of Contents for RNB8910GC
Page 8: ...6 Dimensions RN L 8910GC Cooktop Options...
Page 28: ......