19
Cleaning and Maintenance
Stainless Steel Surfaces
a. With burners removed, clean interior and exterior
surfaces of Cooktop with hot water, a mild detergent
solution and a soft scrubbing brush. Note gas control
knobs are a push fit onto gas control valve spindles
and can be removed to clean front of control panel.
b. Baked on deposits or discolouration may require a
good quality stainless steel cleaner or stainless steel
wool. Always apply cleaner when appliance is cold
and rub in direction of grain.
c. It should not be necessary to remove splash guards
covering burner manifolds for cleaning purposes.
These can be cleaned in situ.
d. Dry all components thoroughly with a dry cloth and
polish with a soft dry cloth.
e. To remove any discolouration, use an approved
stainless steel cleaner or stainless steel wool. Always
rub in direction of grain.
f. Remove grease tray and clean with a mild anti
bacterial detergent and hot water solution using a soft
bristled brush.
g. Dry grease tray thoroughly with a dry cloth.
Re-Fitting the Components to the Cooktop
a. Refit trivet supports to Cooktop, ensuring that trivet
supports are correctly fitted.
NOTE: It is imperative that trivet supports are correctly re-
fitted to appliance to ensure trivets locate correctly
and sit flush and level. NOTE that trivet support
front end, side rail profiles are different at either
side and only one of side rails seat into cut-out in
Cooktop. whereas rear end of trivet support side
rail profiles are the same and have 2 cut-outs to
locate into.
b. Refit burner bowls onto manifolds protruding through splash guards, taking care not to damage
thermocouple (and pilot tube for -PF Option) which is close to manifold.
NOTE: Burner bowl (cast item) has 2 locating holes drilled into base flange (See Fig 7), these are to
locate burner bowl to cap screw on gas manifold when re-fitting burner bowl onto gas
manifold
(Refer to Fig 8 [F-Option] and Fig 9 [PF-Option]).
c. Refit burner caps (cast brass) onto burner bowls already fitted to manifold. These are a loose fit
into burner bowls.
d. Refit trivets to Cooktop, taking note that trivets are manufactured with a lip on one edge, lip must
always be fitted to outer edge (front and back) of Cooktop. (See Fig 10).
e. Refit grease / spill tray(s) to Cooktop.
Burner Base Locates onto
Cap Screw and over Flange
Fig 8
F - Option
Fig 9
Shown without Pilot
Burner Shield fitted.
Pilot Burner
Thermocouple
PF - Option
Notice Lip on
Trivet Edge
Fig 10
Summary of Contents for RN8900G
Page 7: ...5 Dimensions Bench Top Models RN L 8450G B RN L 8900G B ...
Page 28: ......
