Waldorf RN8900G, Installation And Operation Manual

Page: 12 / 28

10
Installation
Clearances
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
* Side clearances can be 50mm when adjacent surface is at least 100mm below cooking surface.
Assembly
NOTE:

All Models are delivered completely assembled. No further assembly is required, with
exception of all Leg Stand Models (RN8450G-LS or RN8900G-LS), these will require
assembly. Refer to 'Leg Stand Models Only' information below for assembly instructions.

The appliance rear leg housings can be fitted with:-
Adjustable feet to assist with levelling of appliance on uneven floors. This should be
carried out on completion of gas connection. Refer to 'Gas Connection Section'.
Rear rollers to enable appliance to be easily moved for positioning and cleaning
purposes.
Optional Accessories (Refer to Replacement Parts List)
 Plinth Kit. For installation details, refer to instructions supplied with each kit.
Bench Models
1. Check all feet are fitted.
2. Adjust four feet to make Cooktop steady and level.
Fitting of Adjustable Feet / Rear Rollers to Leg Stand Units.
1. Remove all pot stands, trivets and open burners.
2. Lower cooktop onto its rear face.
3. Attach four cooktop legs to leg mount points on underside of cooktop unit.
4. Secure each leg hand tight.
5. Align 4 round holes in corners of base tray with 4 cooktop legs already fitted. (Ensure that base tray
is orientated with sloping edge of base tray facing front of appliance).
6. Slot base tray onto 4 cooktop legs and push fully home.
7. Secure base tray to cooktop legs by screwing two front adjustable feet supplied, into base of front
cooktop legs. Secure each adjustable foot, hand tight.
8. The two rear leg housings can be fitted with either adjustable legs or rollers. (See Figure 1).
Combustible Surface Non Combustible Surface
Left / Right Hand Side 250mm (*) 0mm
Rear; -
Standard Models
50mm 0mm
-
Low Back Models
100mm 0mm
To prevent equipment damage and risk of injury, remove all trivets, burner
heads and other removable items prior to fitting the leg stand.
Caution