Waldorf FNL8127E, Installation And Operation Manual

Page: 7 / 19

5
Installation
Installation Requirements
NOTE: It is most important that this appliance is installed correctly and that operation is correct
before use. Installation shall comply with local electrical and health and safety
requirements.
Waldorf Deep Fryers are designed to provide years of satisfactory service, and correct installation is
essential to achieve the best performance, efficiency and trouble-free operation.
This appliance must be installed in accordance with National installation codes and in addition, in
accordance with relevant National / Local codes covering electrical, fire safety and health and safety.
Australia / New Zealand AS / NZS3000 - Wiring Rules.
United Kingdom: BS 7671 - Requirements for Electrical Installations.
Installations must be carried out by authorised persons only. Failure to install equipment to
relevant codes and manufacturers specifications in this section will void warranty.
Unpacking
 Remove all packaging and transit protection from appliance including all protective plastic coating
from door outer panel and exterior stainless steel panels.
 Check equipment and parts for damage. Report any damage immediately to carrier and distributor.

Report any deficiencies to distributor who supplied appliance.
 Check available electrical supply is correct to as shown on rating plate located on inside of access
door.
 Check the following parts have been supplied with appliance:
FNL8127E FNL8224E
Baskets 2 2
Lid 1 1
Drain Extension 1 2
Location
1. Any appliance requires adequate clearance and ventilation for optimum and trouble-free operation.
Minimum installation clearances shown below are to be adhered to.
2. Position the Deep Fryer in its approximate working position.
3. Legs must always be fitted. Ensure that the legs are securely attached.
Clearances
NOTE:

Only non-combustible materials can be used in close proximity to this appliance.

To allow easy operation, drainage and servicing of the appliance, a minimum of 600mm
clearance should be maintained at front of appliance.
Assembly
This model is delivered completely assembled. Ensure that the legs are securely attached.
NOTE:

This appliance is fitted with adjustable feet so that the appliance can be positioned
securely and level. This should be carried out on completion of electrical connection.
Refer to 'Electrical Connection' section overleaf.
Optional Accessories (Refer to Replacement Parts List)
 Rear Roller Kit. For installation details, refer to instructions supplied with each kit.
 Plinth Kit. For installation details, refer to instructions supplied with each kit.
Combustible Surface Non Combustible Surface
Left / Right Hand Side 50mm 0mm
Rear 25mm 0mm