Wahuda 60150ML-WHD, User Manual, Page: 16 / 28

NOTE: This operations section was designed to give instructions on the basic operations of this planer.
However, it is in no way comprehensive of every planer operation. It is strongly recommended that you
read books, trade magazines, or get formal training to maximize the potential of your planer while
minimizing the risks.
ADJUSTING THE TOOL REST
The tool rest should be positioned as close as possible to the workpiece. It should be 1/8” below the
centerline of the workpiece. Rotate the workpiece by hand to make certain you have proper clearance.
WARNING! MAKE CERTAIN THAT THE MACHINE IS DISCONNECTED FROM THE POWER
SOURCE.
Position the banjo (A) on the bed by loosening the banjo lock handle (B) and sliding the banjo to
the desired position. Tighten handle (B) to lock in place. SEE FIG 5
1.
Adjust the height of the tool rest (C) by loosening the tool rest lock handle (D) and raising or
lowering the tool rest. Tighten handle (D) to lock in place. SEE FIG 5
2.
OPERATIONS
16
ADJUSTING BANJO / TAILSTOCK CLAMPING PRESSURE
The clamping device on the banjo and tailstock are set at the factory and should not need adjustment.
However, if adjustment is necessary, see instructions below.
Loosen clamping handle and slide the tailstock or banjo off the end of the bed. Tighten or loosen
the nut beneath the tailstock or banjo and reinstall on bed. Test clamping pressure and repeat if
necessary.
1.
FIG5
C
D
B
A