36
Addendum
a30, a50, z30 and z50 Upgrade Installation Guide
1.
Make certain the power is turned off to the imager to be upgraded.
2.
Verify the serial number on the SD card case matches the thermal
imager to be upgraded.
3.
Insert the SD card into the SD card slot of the imager, located behind
the rubber protection cover on the left side of the imager.
4.
Power on imager.
5.
Upgrade will occur during the imager power on routine.
6.
If Model number is changed, new model number should appear on
screen when powering up.
7.
If High Temperature was enabled, press Menu
→
Setup
→
Measurement and with Temp Range highlighted the left/right arrows
should allow selection of the High Temperature range.
8. Note!
After completion of upgrading, the remaining file may be
deleted from the SD card and the card may be used for image
storage.
In the event you require technical assistance, you may call our customer
service department at 1-800-421-2853 or at the number listed below.
234 Old Weaverville Road, Asheville, NC 28804
Toll Free: 800-421-2853 • Phone: 828-658-3131 • Fax: 828-658-0728
www.palmerwahl.com
