58
Parameterizing
WAGO-TO-PASS® 761
761-314 TO-PASS® Mobile, 4 AI
Manual
Version 2.0.0
Pos : 34.14 / Serie 759 ( WAG O-Soft ware)/T O-PASS Konfig urati onssoft ware/ Parametrier ung/ Par ametrierung I /O M ulti plex Ei nst ellungen @ 3\ mod_1223558973578_21. doc x @ 23777 @ 4 @ 1
7.5.2.1
Multiplex Settings
Select your
TO-PASS
®
telecontrol module from the left side of the project tree
using the identifier. Select the
Multiplex Settings
option under
Multiplex Input
.
The buttons for enabling multiplex operation and the selection of the recipients of
the analog values to be transmitted are provided on the right side.
Figure 24: Configuring multiplex operation settings
Table 27: Configuring multiplex operation settings
Enable/Addresses
Multiplex
operation
Click the button
[Use]
to enable/disable multiplex operation
for digital inputs DI1 ... DI4.
If a status combination of digital inputs DI1 ... DI4 is fulfilled
in multiplex operation for which a message text has been
defined, a corresponding message will then be sent (see
below).
Address
Use this button to select the addresses to which the message
is to be transmitted when the corresponding status
combination of digital inputs DI1 … DI4 is fulfilled.
Click the button
[Internet]
for applications with GPRS
transmission.
Analog value
Use these buttons to select four analog values which can also
be transmitted with the message text when the corresponding
status combination of digital inputs DI1 … DI4 is fulfilled.
Pos : 34.15 /D okument ati on allgemei n/Gli ederungsel ement e/---Seit enwec hs el--- @ 3\ mod_1221108045078_0. doc x @ 21810 @ @ 1
