WAGNER W200, Manual

Page: 15 / 22

23
W 200 GB
12) Unscrew the union nut and remove the air cap and nozzle. Clean the air cap, nozzle
seal and nozzle with a brush and solvent or water (Fig. 12, 5).
13) Clean the outside of the spray gun and container with a cloth soaked in solvent or water.
14) Assemble the parts again (see “Assembly”).
Assembly
The unit may only be operated with an integer diaphragm (Fig. 12 A, 16).
1) Place the diaphragm (Fig. 12 A, 16)
with the pin facing upwards
on the bottom section
of the valve. Also see the marking on the gun body.
2) Place on the valve cover (Fig. 12 A, 15) and screw it closed.
3) Place the ventilating hose (Fig. 12 A, 14) on the valve cover and on the nipple at the
gun body.
4) Push the nozzle seal (fig. 12 B, 4) over the needle (19); the groove (slot) should point
towards you.
5) Put the nozzle onto the gun body and find the correct position by turning it. (Fig. 10)
6) Put the air cap (Fig. 12, 2) onto the nozzle (3) and tighten it using the union nut (1).
7) Place the container seal (Fig. 12, 13) from below on the suction tube and slide it over
the collar, while turning the container seal slightly.
8) Insert the suction tube with container seal in the gun body.
14. Maintenance
WARNING!
Never operate the machine without the air filter; dirt could be sucked in
and interfere with the function of the machine. Disconnect plug before
changing parts.
Change the air filter if it is soiled. For this pull the air filter out of the unit (Fig. 11). Insert a
new air filter with the flat side at the back (looking towards the unit).
In order to mount the gun more easily apply lubricating grease (enclosed) liberally
to the O-ring at the gun front part (Fig. 12, 18).