WAGNER W200, Manual

Page: 13 / 22

21
W 200 GB
•
Set the container on a sheet of paper, pour in the prepared coating material and
screw the container tightly onto the spray gun.
•
Connect the front part with the rear part of the gun. (Fig. 5)
•
Mount the air hose (Fig. 4, a + b). Insert the air hose firmly into the connection of the
unit and the gun handle. The position of the hose is not relevant.
•
Insert the spray gun into the gun holder on the unit.
•
Put the machine down only on a level, clean surface. Otherwise, the gun may suck in
dust, etc.
•
Sling on the carrying strap with the unit.
•
Remove the spray gun from the gun holder and point it at the object to be coated.
•
It is advisable to test spray cardboard or a similar material in order to determine the
material quantity and the spray pattern.
•
Press the ON/OFF switch at the device.
9. Adjusting the desired Spray Setting
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
With the union nut (fig. 7, 1) slightly unscrewed, turn the air cap (2) to the desired
spraysetting position (arrow). Then tighten the union nut.
Fig. 6 A = vertical flat jet

for horizontal surfaces
Fig. 6 B
= horizontal flat jet

for vertical surfaces
Fig. 6 C
= circular jet

for corners, edges and hard-to-reach surfaces
10. Adjusting the Material Volume (Fig. 8)
Set the material volume by turning the regulator on the trigger guard of the spray gun
-
turn to the left

lower material volume
+ turn to the right

higher material volume
11. Spray Technique
•
The spray result depends heavily on the smoothness and cleanliness of the surface to
be sprayed. Therefore the surface should be carefully prepared and kept free of dust.
•
Cover all surfaces not to be sprayed.
•
Cover screw threads or similar parts of the target object.
•
It is advisable to test the spray gun on cardboard or a similar surface to find the
correct setting.
Important:
Begin spraying outside of the target area and avoid interruptions inside
the target area.