WAGNER SUPER FINISH 23 CR, Operating Manual

Page: 35 / 120

35
Super Finish 23 CR
EN
TRANSPORTATION / HANDLING THE HIGH-PRESSURE HOSE /
INTERRUPTION OF WORK
5
TRANSPORTATION
Pull out the drawbar until it audibly engages.
To retract the drawbar press the two locking buttons (1).
6
HANDLING THE HIGH-PRESSURE
HOSE
The unit is equipped with a high-pressure hose specially suit-
ed for diaphragm pumps.
Danger of injury through leaking high-
pressure hose. Replace any damaged high-
pressure hose immediately.
Never repair defective high-pressure hoses
yourself!
The high-pressure hose is to be handled with care. Avoid sharp
bends and folds: the smallest bending radius is about 20 cm.
Do
not drive over
the high-pressure hose. Protect against
sharp objects and edges.
Never pull on the high-pressure hose to move the device.
Make sure that the high-pressure hose cannot twist. This can
be avoided by using a Wagner spray gun with a swivel joint
and a hose system.
When using the high-pressure hose while
working on scaffolding, it is best to always
guide the hose along the
outside
of the scaf-
folding.
The risk of damage rises with the age of the
high-pressure hose.
Wagner recommends replacing high-pres-
sure hoses after 6 years.
Only use WAGNER original-high-pressure
hoses with internal heating in order to ensure
functionality, safety and durability.
7
INTERRUPTION OF WORK
If using quick-drying or two-component
coating materials, do not fail to rinse unit
through with a suitable cleaning agent dur-
ing the processing period. Follow for the rel-
evant instructions in chapter 8.
1. Open the discharge tap, then set the ON/OFF switch OFF.
2. Pull the trigger on the gun or open the material ball cock
to depressurize the high-pressure hose.
For spray work
3. Secure the gun, refer to the operating manual of the gun.
4. Remove tip from tip holder and store the tip in a small ves-
sel with suitable cleaning agent.
Transportation in vehicle
Secure the unit in the vehicle by means of suitable fasteners.
The device can be placed on its side if necessary. In this case,
please ensure that no attachments can be damaged. Atten-
tion: Paint or solvent residues can escape from the connec-
tions!
1
-