English
© Wagner Spray Tech - All Rights Reserved
9
Cleanup
Cleaning the nozzle
To Clean the Nozzle:
1. Make sure power cord is unplugged.
Push the tab below the trigger, twist and separate the
nozzle from the turbine. Wipe the exterior of the cup and
nozzle until clean.
2. Unscrew the nut and remove the air cap and nozzle.
3. Remove the parts as shown*. Clean all parts with a
cleaning brush and the appropriate cleaning solution.
Reassemble when clean**.
4. Clean the air vent (c) on the suction tube with a soft
bristled cleaning brush.
5. Clean the rear of the nozzle (d) with the appropriate
cleaning solution. Use a thin layer of petroleum jelly to
lubricate the O-ring (e).
(d)
(e)
(c)
5
4
3
2
1
**
It is important that the nozzle
seal inside the nozzle be re-installed
properly. Make sure the cup side of the
seal (the side with the groove) is facing
out towards the front of the nozzle.
Groove
* Nozzle seal
The red nozzle seal may become
stuck inside the spray nozzle
when the nozzle is removed. If
this occurs, make sure to pull
it out.
