WAFER GSM-CTL REMOTE CONTROL UNIT
http://www.waferstar.com
• To check which is the number in a place of the list:
#PWD123456#WHL01?
Acknowledge
: WHL01 IS 61143815 OK
• To erase a number:
#PWD123456#WHL01=0000000
(or you can write over it another number you wish to add)
Acknowledge :
WHL01 SET TO 00000000
List All numbers in the List
#PWD123456#WHL=ALL?
(
PC)
Acknowledge
:
WHL01 IS XXX
WHL03 IS XXX
WHL08 IS XXX
……
#QUERY
White List
.
If you are not sure a number in the position of the device,you can use the SMS
#PWD123456#QUERY=132324242
The device would answer the SMS with: QUERY RESULT: 132324242 AT WHL121
Or QUERY RESULT: 132324242 NOT EXIT
#GOT
Relay working output delay time.
This command is useful in case you need to keep the Relay output working longer. The standard
time is 0,3 seconds (300 ms). You can change it with the GOT command.
• The syntax of the command is the following:
#PWD123456#GOT500
(
PC$PHONE)(Only for NO.1 Relay)
Acknowledge
:
DELAY TIME SET TO 0500MS
With the above command the delay time has been set to 500 ms (0,5 seconds).
• You can check what the current relay output delay time is with the command
#PWD123456#GOT?
(
PC$PHONE) (Only for NO.1 Relay)
Acknowledge
:
DELAY TIME IS 0500 MS
Also you can change the Timer Ratio from millisecond to Second or Minute
#PWD123456#TIMER-DELAY-AT-MILLISECOND;
#PWD123456#TIMER-DELAY-AT-SECOND;
#PWD123456#TIMER-DELAY-AT-MINUTE;
#MODE Relay Operation Mode SETUP
(PC$PHONE) (Only for NO.1 Relay)
#PWD123456#MODE0
Acknowledge
: RELAY SET TO MODE0
#PWD123456#MODE1
Acknowledge
: RELAY SET TO MODE1
If set to MODE0,that is
Momentary pulse and If Config to MODE1,that is Ratchet relay
If setup to MODE0,that is Momentary pulse mode, when you call the SIM card number , device will toggle the
