WAFER GSM-CTL REMOTE CONTROL UNIT
http://www.waferstar.com
Remember that commands must be CAPITAL LETTERS. It is PWD not pwd, CAP not Cap
etc. Don't add spaces or any other character.
Some complicated Instructions,that cann’t be programmed by the phone SMS. That would
need to use the PC software to program and inquiry the status of the terminal.
The below wire picture is to show how to connect the cable to the PC program connector with
the Program adapter.Please connect it in the right direction with the picture.
The following compand is used in the GSM-CTL :
#PWD
:
Password
#CAP
:
Change password
#WHL
:
White List (add or remove numbers)
#ACM
:
Safety control mode or free control mode
#REPLY
:
When send the SMS to control,if need to reply the SMS
#GOT
:
Relay working output delay time
#MODE:
Relay mode
#CSQ
:
Check Signal Quality
#STATUS
:
Check status
Once you issue a command with an SMS, you will receive a confirmation SMS with OK
if everything is correct or Err if there is an Error.
GSM-CTL SMS COMMAND LIST:
#PWD
Password
.
This command must always come first 6 digits as a password.
The standard default one, when the device comes from the factory, is 123456.
We suggest that you change it, using the #CAP command.
In all the following examples we will use 123456 as an example of password.
#CAP
Change Password
.
Use this command to change the password with a new one that you will chose for your device
( don't forget it or you will have to send the unit back to us to reset it, and this has a cost )
The #CAP command must be issued 2 times to be sure you don't digit a wrong one.
OF course it must be preceded by the old password.
For example, to change the password 123456 into the new password 333444 you need to send the
following SMS:
