WAFER GSM-CTL-AC REMOTE CONTROL UNIT
http://www.waferstar.com
Please note that it is possible to program up to a maximum of 10 digits for a number. If it has
more digits you should use the rightmost ones. For example, if your number is 33446665555 you
should program 3446665555. If your number appears as +85261143815 you should not program
the country code (+852). If your number has only 9 digits or less, it is not a problem. The
important thing is that you don't exceed 10 digits.
• To check which is the number in a place of the list:
#PWD123456#WHL01?
Acknowledge
: WHL01 IS 61143815 OK
• To erase a number:
#PWD123456#WHL01=0000000
(or you can write over it another number you wish to add)
Acknowledge :
WHL01 SET TO 00000000
List All numbers in the List
#PWD123456#WHL=ALL?
(
PC)
Acknowledge
:
WHL01 IS XXX
WHL03 IS XXX
WHL08 IS XXX
……
#GOT Relay working output delay time.
This command is useful in case you need to keep the Relay output working longer. The standard
time is 0,3 seconds (300 ms). You can change it with the GOT command.
• The syntax of the command is the following:
#PWD123456#GOT500
(
PC$PHONE)(Only for NO.1 Relay)
Acknowledge
:
DELAY TIME SET TO 0500MS
With the above command the delay time has been set to 500 ms (0,5 seconds).
• You can check what the current relay output delay time is with the command
#PWD123456#GOT?
(
PC$PHONE) (Only for NO.1 Relay)
Acknowledge
:
DELAY TIME IS 0500 MS
#MODE Relay Operation Mode SETUP
(PC$PHONE) (Only for NO.1 Relay)
#PWD123456#MODE0
Acknowledge
: RELAY SET TO MODE0
#PWD123456#MODE1
Acknowledge
: RELAY SET TO MODE1
If set to MODE0,that is
Momentary pulse and If Config to MODE1,that is Ratchet relay
#OUT Relay output control (ONLY when the DIP Switch is switched to ON position)
(1)ON the relay output contact
#PWD123456#OUTX=ON
(
PC$PHONE)
Where X is the number of the relay in the list (X is from 1 to 2)
Acknowledge
:
OUTX ON OK
